Many drivers wonder why their brake lamp lights up on the dashboard of their Honda cars and what they should do about it. This can be quite alarming when it happens, especially if you’re not sure what’s causing the problem.
So why the brake lamp comes on in the honda dashboard could indicate something as simple as low brake fluid in your vehicle or something more complex, like ABS issues or faulty brake sensors that need to be replaced.
This article, therefore, seeks to shed light on everything you need to know about the brake lamp light error code in a Honda car.
Contents
Causes why Honda brake lamp error light is on?
If the brake lamp comes on in your Honda, it’s likely due to one of four reasons:
1. Burnt out bulb
This is one of the most common causes of a brake light error in a Honda. Think of the light as a straw that needs air to continue operating.
The burnt-out bulb will not be able to get air, which is why the brake lights are extinguished while driving. So how do you fix this problem?
It all depends on your car type and how much experience you have with cars. For example, if you own a newer model Honda Civic with front and rear brakes, then the best way to fix this issue would be by replacing both bulbs simultaneously because they’re connected.
However, if you have an older car or just need to replace one bulb, it’s usually better to change them individually.
2. Brake fluid low
When the brake fluid becomes too low in your Honda, this can cause the warning light to illuminate and put pressure on the brakes, causing them to feel sticky or too hard.
To solve this issue, ensure you refill your reservoir with new fluid so there isn’t any excess pressure on the system. You may also want to take your car to a mechanic for a checkup so that they can inspect the entire system and find out if anything else might be wrong.
3. Bad brake light switch
Another cause for a brake light coming on in your Honda could be a faulty brake light switch. This switch is responsible for telling you when your brake lights are working, and it can become damaged over time with excessive use or from getting wet.
To fix a broken switch, you must replace it or bring your car to a mechanic for an inspection. The process usually takes about 20 minutes and doesn’t require special tools, so it should be fairly easy to complete.
4. Blown fuse
Another reason for a brake light coming on in your Honda could be a blown fuse. Fuses control electrical currents by protecting circuits from overloads or shorts.
If the circuit blows, it means that electricity cannot travel through that specific area of the vehicle anymore, and everything shuts down, including the brake lights.
Therefore, if the brake light is illuminated on your dashboard and the engine isn’t running, a fuse may have blown. All you have to do is pop open the hood of your car and look for something that resembles a fuse box.
Unplug each fuse until you find the one labeled brake or stop. Replace it with a new fuse!
How much does it cost to repair the brake lamp error?
It is important to note that the cost of repairing the brake lamp error will vary depending on the severity of the problem. If the problem is a simple blown fuse, then it will be relatively inexpensive to fix.
However, if the problem is more serious, such as a faulty brake light switch, it will be more expensive to repair. The average cost to fix is about $150 including labor.
Can you drive with the brake lamp light on?
Driving with the brake lamp light on is dangerous because other drivers may not see your car and cause an accident. If the brake lamp light comes on for an extended period, then it might be time to take your car to a mechanic to have them diagnose what the problem could be.
It is possible that your brake fluid needs to be changed, or something might be blocking the fluid lines in the back brakes.
Where is the brake lamp located?
Two are situated on any side of the rear bumper, and one is normally mounted mainly at the back window.
Conclusion
In a nutshell, the Brake lamp light in Honda is a common problem that must be dealt with. However, brake lamps are designed to illuminate when they detect braking to help other drivers know you’re slowing down.
If the light remains illuminated, it might be worth having your brakes checked by a mechanic.
