Contents
2010 Honda CR-V Lug Nut Torque Guide
| Measurement | Value | Source |
|---|---|---|
| Pound-feet (lb-ft) | 80 lb-ft | Honda Service Manual, Bulletin 12-001 |
| Newton-meters (Nm) | 108 Nm |
⚠️ Warning
Exceeding 90 lb-ft risks stud fracture; below 70 lb-ft may cause wheel loosening.
Potential Risks of Incorrect Torque
- Over-torquing: May lead to stud stretching/breakage, warped brake rotors, or stripped threads
- Under-torquing: Can cause wheel vibration, loosening lugs, or complete wheel detachment
- Uneven torque: Results in distorted brake rotor surfaces, leading to pedal pulsation
Proper Torque Procedure
Required Tools
- Click-type torque wrench (3/8″ or 1/2″ drive recommended)
- Lug nut socket (19mm for OEM wheels)
- Wheel chocks and jack stands (never rely on jack alone)
Tightening Sequence
Use a star pattern for even distribution:
1
5 2
4 3
Step-by-Step Process
- Raise the vehicle and secure it with jack stands
- Hand-tighten all lug nuts in sequence
- Torque to 30 lb-ft (40 Nm) in sequence (snug setting)
- Final torque to 80 lb-ft (108 Nm) in sequence
- After lowering the vehicle, verify the torque again
Special Considerations
Aftermarket Wheels
Consult the wheel manufacturer for specs – may require different torque or lug nuts.
Impact Wrenches
Never use for final tightening. Only for initial loosening/installation before the torque wrench.
Thread Lubrication
⚠️ Never lubricate threads unless specified by Honda. Dry threads are critical for proper friction.
Retorquing
Recommended after 50 miles (especially with alloy wheels) or after wheel service.
Troubleshooting FAQ
Q: My torque wrench doesn’t reach 80 lb-ft – what now?
A: Use a 1/2″ drive wrench with higher capacity. Never guess torque.
Q: Can I reuse stretched lug nuts?
A: No – replace any stretched or damaged lug nuts/studs immediately.
Q: What if I stripped a lug stud?
A: Requires immediate replacement – don’t drive until repaired.
